Mga pipol na may storm din,patulong naman, nakabili ako ng storm na 2nd hand, for only 40k with 200km only. ang kaso wala akong manual.

I would like to change the engine oil and gear oil. paano po ba,. thanks

It's the exact same procedure as on other scooters. Oil drain plug is found on the bottom of the crankcase and the dipstick/fill hole is on the right side of the motor adjacent to the intake fan. Just look for the black knob.

BTW, where are you located?

step by step ganto yun sa engine oil.

1)warm up muna yung makina
2)tanggalin mo yung dipstick sa ibabaw ng fan (fan yung itim na plastic sa right side ng makina mo)
3)kuha ka ng lalagyan at tanggalin mo yung turnilyo sa ilalim ng makina, isa lang naman yung medyo nakagitna na yun, yan ang drain.
4)pag patak patak na lang, kung meron kang degreaser yung di ispray, ay ipanglinis mo, kung wala, pwede na ang simpleng gaas.
5)pataktakin mo ulit at ok na yan.
6)linisin mo rin ang maliit na filter sa ilalim ng drain at ibalik ang turnilyo ng malinis.
7)lagyan mo ng 800ml 10W/SAE40 motor oil (wag diesel at hwag muna synthetic)
8)ibalik ang dipstick ng malinis.

im from caloocan, wala na bang filter ito gaya ng oto? eh yung sa gear oil saan po ba yun?

minor problem nga pala nito eh yung backlight ng lcd eh madalas patay. minsan mag kakaroon for a split second lang tapos wala ulit.


thanks..

Shibby,

Eto, I just changed the oil on my Storm150 and made a tech article for it just for you. Take a look...

http://motorcyclephilippines.com/forums/showthread.php?s=&threadid=7416

===========

Your intermittent LCD backlighting is most probably caused by a loose connection. You can check it by removing the back panel on the leg shield and checking all the white socket connectors going to the gauge panel.

gusto ko nga tangghalin yung buon front ng skoot, pero may turnilyo sa ilalim ng chin na accesible lang pag tinggal ko yung buong gilid, yun bang gray na plastik. anhirap nun.

pero pwede naman pagjagaan, gusto ko lang sana ma-adjust ang sensitivuty ng alarm. paano po ba yun?

Shibby,

You don't need to remove those two screws just to remove the entire front end of the scoot. Ako nga madalas magkalas ng harapan ng scoot just to clean it inside and out. All you need to do is to remove the 4 screws sa likuran ng legshield and the entire front end assembly will come off. The two screws sa chin plate actually just go through two holes on the underside of the face but they are not bolted on. May butas lang sa ilalim ng chin para shoot yung bolts, but they do not actually come into contact with the face panel. Naloko rin ako nun dati but I eventually found out after trial and error. :D

nakakita nga pala ako ng soundsystem na kinabit sa storm.

pati yung bilog na suppose to be water coolant dapat na nasa tabi ng gas, eh nilagyan ng speaker

Shibby, kung gusto mo tanggaling yung harap, may dalwang screws sa ilalim ng harapan, ibabaw lang ng front fender then yung tinuro ni GSChan nag apat na screws, tanggal na buong harap ng skut mo. :) Be sure nga lang na secured yung screws pag iabalik mo na. :D

Yung sound system, pwede rin trailer nalang para hindi sagabal sa compartment ..... pero hindi ko nga lang alam kung legal. :D

Sad to say, sinauli ko na yung skut sa binilhan ko, hirap ipa register kasi kulang sa papers.

Just been to 10th ave, nakita ko yung mga china imitation na dink scooters.

I preffered the dayang brand, kasi 1 year ang waranti, and ang difference nya from others imitations is yung disk brake lang sa likod.

It is not as strong when it comes to acceleration, but it has a better ride and handling than the storm150

Sad to say, sinauli ko na yung skut sa binilhan ko, hirap ipa register kasi kulang sa papers.

Just been to 10th ave, nakita ko yung mga china imitation na dink scooters.

I preffered the dayang brand, kasi 1 year ang waranti, and ang difference nya from others imitations is yung disk brake lang sa likod.

It is not as strong when it comes to acceleration, but it has a better ride and handling than the storm150